22nd October 1927, Page: 107, Column: 1
Coal Mining In India
At the annual general meeting of the Manchester Geological and Mining Society,
held on the 11th October, Mr. G. S. Caldwell, manager of the Victoria
Colliery, which is situated on the northwest boundary of the Bengal or Kanegunj
coalfield, and owned by the New Beerbhoom Coal Co., presented a paper under the
title "Notes on Indian Mining or Experiences on an Indian Colliery."
The colliery is served by four shafts, the Heslop and Manghan pits reaching the
workable coal seams at about 320 feet, and the Nos. 3 and 4 pits reaching the
same seams at about 550 feet. The first workable seam met after passing through
various sandstones and shales, is called the Top seam, varies from 8' 6"
to 10' in thickness, and contains only one parting of shale about one inch
thick three feet from the roof. The average ash content of this seam is 8 per
cent. The method of working is to cut the seam up into pillars usually 80' by
80' right to the boundaries and then extract them retreating. Galleries are
driven 10' to 12' wide the full thickness of the seam, no props or supports
being required, the roof being strong sandstone. This Top seam gives off quite
a lot of gas, but at very irregular intervals, apparently from pockets under
high pressure. Safety-lamps are used throughout the colliery, and these give a
comparatively good light on a small consumption of kerosene without smoke.
Mr. Caldwell says the workpersons are addicted to purloining the lamps
for domestic uses. The Middle seam is reached after passing through 9' of
sandstone and one foot of black shale. This seam varies from 4' 6" to 6'
in thickness, and is all clear coal except for 6" near the floor which is
hard and bony. The ash content of this seam is about 10 per cent. This is
considered a thin seam and only certain classes of miners can be got to work in
it. Passing through a further 10' of sandstone the Bottom Thick seam is reached
and varies from 35' to 30' in thickness at Victoria. The ash content is about
12 per cent. The Top and Middle seams are quite dry, but the Bottom seam is
rather wet, all the water being contained in the sandstone above the Bottom
seam and under the Middle seam. As the dip area is developed the water follows
down, percolating through the roof as each cleavage is uncovered, leaving the
rise workings to dry up. The Bottom seam at Victoria has a very striking
feature in its nodular structure. The seam is interspersed with several layers
or bands of very dense bony coal or shaly bands, and it is in close proximity
to these, both above and below, that the nodular formation finds its most
concentrated form. Mr. Caldwell mentions that one day about two years
ago, after making an underground inspection, he got to the pit bottom to find
that the sun was perpendicularly over the shaft. The shaft was perfectly
illuminated, and every pebble in the pit bottom could be seen with ease. He
took the opportunity to make a careful inspection of the shaft sides, which are
not walled and very irregular in places, but before he could reach the surface,
going at the slow inspection speed, the sun had passed out of its favourable
position. It was very useful to be able to see every crevice and cleat so
plainly. In the view of Mr. Caldwell, the better qualities of Indian
coal will compare very favourably with other coals in the East. He compares the
better grades with an average Lancashire Yard coal. The Coal Grading Board
recently formed by the Government of India is having a beneficial effect on the
export trade, the Board having set up a high standard which is rather difficult
to meet, especially at those collieries that have not been provided with
screening and picking plants. A minimum size of 2" cubes for steam coal
has been set up, and as the Board only deals with export coal the aim is to
have the coal landed at its destination in as good a condition as coal conveyed
direct by wagon would be. After the coal has been graded it is further
inspected as it is loaded at the colliery, and again at the docks as it is put
aboard ship. To overcome the loading difficulty Mr. Caldwell has taken
out a patent for a portable screening, picking and loading machine, which is
under process of development. The machine is designed chiefly to deal with the
common layout of Indian collieries, and to satisfy the standard laid down by
the Grading Board, putting Indian coal in a much better marketable condition to
recapture its export market.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Caldwell, G. S. | | Colliery Manager | |