|
13th August 1927, Page: 26, Column: 1 Examination QuestionsFirst Class or Colliery Managers.WINNING AND WORKING. 1. Describe the conditions which would influence you in deciding to work by longwall advancing, longwall retreating, and pillar and stall methods respectively. Sketch a lay-out plan of one of the above methods. (50) 2. The workings of a coal seam are cut off by a fault which appears to be a large one and which has not previously been pierced. Describe in detail what you would do in order to ascertain the throw of the fault and win the coal on the other side. (40) 3. Show by sketches the construction of a bricking scaffold for use in a sinking shaft, and the method of suspending it. What is the procedure when the scaffold has to be raised when brickwork is being put in? (40) 4. Give particulars, along with sketches, of the type of cage guides you would install in a shaft of small diameter, paying particular attention to the top and bottom of the shaft. (40) 5. Where coal conveyors of the jigger type are in use along a face dipping 1 in 5, and foreign dirt is required for completely packing the waste, how would you arrange for transporting this dirt along the face? (40) 6. Describe briefly the diamond method of boring, and give sketches of the principal working parts of the plant. (40) 7. In order to obtain the maximum output per man per shift from the coal face, to what particular points, other than coal-cutters and conveyors, would you direct your attention? (40) THEORY AND PRACTICE OF VENTILATION. 1. On the plan of a mine which accompanies this paper show how you would ventilate the working faces by means of four separate air-currents (splits) and three air-crossings. Show the direction of each air-current and the positions of air-crossings, doors, stoppings, regulators and sheets, and avoid placing air-crossings in positions in which they would obstruct the haulage. (30) 2. What is the normal composition of air? What effect does a gradual reduction in the proportion of oxygen produce: (1) on men; and (2) on the flame of an oil lamp? What is blackdamp; how is it supposed to be formed in a mine; and how can its proportion in the air of a mine be most easily estimated ? (30) 3. From what various sources does the air of a mine acquire its content in moisture; how is this content usually ascertained in what units of volume, or weight, is it generally reckoned; and in what manner does it, in some cases, affect the health of the workmen? (30) 4. Sketch and describe a gauzeless safety-lamp; or, alternatively, sketch and describe a combustion-tube safety-lamp showing the details of its air passages. (30) 5. A ventilating fan is drawing 340,000 cubic feet of air per minute through the workings of a mine with a water-gauge of 6 inches. Calculate: (a) The horse-power in the air. (b) The weight of air passing per minute, when its temperature is 72° F., and the height of the barometer at the point where its volume is being measured is 31 inches. (30) 6. Other things being equal, at what time of the day, and on what day of the week, would you expect to find the greatest proportion of firedamp in the return air of a mine in which two shifts of eight hours each per day five days per week were being worked? Give your reasons for your answer. State how you would propose to deal with the contingency that some parts of the workings threatened at any time to become dangerous owing to the presence of an excessive proportion of inflammable gas. (30) 7. What would be the volume of a mass of air weighing 1,000 lb. under a barometric pressure of 31 inches and at a temperature of 40° F.; and what would be the volume of the same weight of air at a pressure of 28 Inches and a temperature of 80° F. ? (50) EXPLOSIONS, &c. 1. A seam of coal of the following section is liable to spontaneous combustion:
The inclination of the seam is 300, and the depth from the surface is 500 yards. What method of working would you adopt to reduce the risk of spontaneous heating? Explain the advantages of your method, and show how you would deal with a serious case of heating if it arose. A sketch plan should accompany your answer. (30) 2. Enumerate the circumstances in which a rescue brigade should be sent for, and state the nature of the instructions that should be given by the manager to the captain, and by the captain to his team before undertaking the work. (25) 3. How can the analysis of mine air be of use in the detection of the early stages of spontaneous heating? Give characteristic analyses of samples of mine air showing :— (a) Normal return air. (b) Abnormal return air indicative of dangerous conditions. (25) 4. A shaft, 18 ft. dia., being sunk through strata inclined at 45°, at a depth of 200 yards, is approaching very old longwall workings — believed to be flooded. What dangers would you apprehend and what precautions would you take to carry the sinking safely through the old workings? (25) 5. What evidence from observation would you endeavour to obtain when investigating the circumstances of an explosion in a large colliery in order to define the parts of the workings traversed by flame. (25) 6. Sketch and describe the construction and equipment of a first-aid and ambulance room suitable for a colliery in which 1,000 men are employed underground. (25) MACHINERY. 1. A horizontal 3-throw pump is to be driven by an electric motor of 60 b.h.p. running at 870 r.p.m. The pump crankshaft runs at 38 r.p.m. Make a diagram showing on plan how you would arrange the gearing for the drive. Indicate the pump crankshaft, the motor shaft, the intermediate shafting and the gear wheels. (28) 2. A vertical leg of a headgear is a steel joist 12 in. by 6 in. in section. Design a base for this leg suitable for resting on, and being secured to, a pier of brickwork or of concrete. Show all important dimensions and details of design. (38) 3. Outline a scheme for a complete economical electric power plant to provide for a steady load of 1,000 kilowatts during the morning shift and a load of 500 kilowatts during the other two shifts. (28) 4. In Lancashire boilers how is the front plate secured to the shell and to the flue tubes? How does welding enter into the construction of a Lancashire boiler? What is caulking as applied to boilers? (28) 5. What is a squirrel cage motor? For what purpose is a squirrel cage motor suitable? How are squirrel cage motors started? (28) 6. Water is fed into a boiler at 60° F. and is converted to steam at 100 lb./sq. in. gauge pressure at the rate of 5,000 lb./hour. The consumption of coal is 1,000 lb./hour, its calorific (or heat) value being 9,000 B.Th.U.'s/lb. What percentage of the heat value of the coal is imparted to the water in raising steam? Use the following data
SURVEYING, LEVELLING AND DRAWING. 1. How would you make a short traverse over heavy rails with a loose needle dial? Illustrate your method by giving imaginary observed needle readings at four stations over the rails, and work out the correct bearings. (30) 2. Reduce the following field notes of a levelling and plot a section to a scale of one inch to 50 feet for horizontals, and one inch to 10 feet for verticals. Figure the section to show the depth of cutting, or filling, at each fifty feet, making a uniform gradient from A to B.
What is the gradient from A to B ? (30) 3. The accompanying plan shows a hand sketch of the timbering of a rectangular shaft. Sufficient detail is given to enable you to draw a plan of the shaft. The shaft is eighteen feet long by ten feet wide in the clear. It is divided by buntons into a pump space at one end, two cage spaces and a rope space at the other end. The pump space is 4 feet 9 inches by 10 feet in the clear, each cage space is 4 feet 6 inches by 10 feet in the clear. Draw a plan to a scale of (30) 4. From the sketch plan referred to in question 3 calculate the quantity of timber in cubic feet in a yard of shaft, setting out in detail the quantity in each item of the timbering. The calculation can be made without drawing the plan. (25) 5. A leasehold of 1,500 acres has been proved by six bores, distributed fairly regularly over the area, to contain three seams of coal 12 1/8 feet in aggregate thickness, specific gravity 1.280. Calculate the quantity of coal in the leasehold, making the allowances you consider reasonable in the circumstances to arrive at the probable quantity of workable coal. Assume the strata to be level. (25) 6. The azimuth bearing of a heading in a coal seam is 110°, and its inclination 10°. If the azimuth of the strike line be 40°, find, by plotting or by calculation, the rate and quadrant bearing of full dip. Assume the instrument used to be a loose needle dial and the graduation to be clockwise. (25) GENERAL MANAGEMENT AND MINING LEGISLATION. 1. Compulsory Question. — Write a report to your directors on the application of hydraulic stowing to reduce damage to the surface by underground workings. Discuss its practicability in this country. (30) 2. Explain the effect of the changes made in regard to the qualifications of candidates for certificates of competency by the recent order of 23rd December, 1926. (25) 3. Quote the General Regulation 123 as to precautions to be taken to prevent danger or mechanical damage to transformers and switch gear. Four notices are required by General Regulation 121 to be exhibited where necessary. To what do they each relate and where are they to be exhibited? (25) 4. What is the definition given in the Coal Mines Act, 1911, of (a) "A place not deemed to be in a fit state for working or passing therein." (b) "An intake airway not deemed to be normally kept free from inflammable gas." From what mixture of air and inflammable gas must men be immediately with drawn? (25) 5. Quote the General Regulations as to taking samples of coal dust for the purpose of testing its composition. (25) 6. Enumerate the provisions under the Coal Mines Act, 1911, as to the relighting of safety-lamps underground. (25) * Questions set at Examinations in May, 1927. The figures in brackets against each question indicate the maximum number of marks obtainable. The plans and sketches have not been reproduced. Price of official copy of questions obtainable through H.M. Stationery Office. 1s 9d. net.
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||