2nd July 1927, Page: 385, Column: 2
Improved Face Conveyor
At the recent meeting of the Mining Institute of Scotland Mr. Albert V. Reis,
B.Sc, read a paper on "An Improved Pace Conveyor." It is a
belt carried by rollers in cradles, but furnished with fixed sides or frames,
which takes the shape of a trough in which the belt forms the bottom. In order
to maintain alignment of the rollers and cradles, the framework is made
continuous from end to end of the face conveyor. The cradles and rollers are
attached and form part of the framework, so that rollers are always maintained
at right angles to the line of the belt. The framework unit consists of a steel
plate riveted to an angle iron which forms a side. The angle irons carry a pin
at either end which fits into a corresponding hole in the cradle carrying the
rollers, so that each unit of framework is fixed to the adjacent members. The
framework fulfils a dual purpose. It serves to maintain the alignment of the
belt by fixing the position of the rollers at right angles to the line of the
belt, and the steel plates form sides, which makes it easy for the miner to
load the coal on the belt. The sides of the framework project 2 inches above
the belt at the face side, whereas at the waste side the height above the belt
is increased to 4 inches. The miner stripping the coal receives considerable
assistance from this framework in that the coal can be thrown with no greater
effort on to the belt than in the case of the shaker conveyor. The framework or
cradles have been designed to place the belt as low as possible for two reasons
: (1) To afford a low-lying trough so that the stripper is required to make the
least effort in throwing the coal on to it; (2) to give the greatest clearance
between the top of the belt and the roof of the seam. The belt is carried an
rollers 9 inches above the floor level. On the face side, the height of the
framework is 2 inches above the belt, or a total of 11 inches over which the
coal has to be thrown on to the belt. In comparison, the height of the shaker
pan and shaker conveyor varies from 8 to 10 inches above the floor level. The
rollers are 2½ inches diameter and held in position by a simple lubricated
casting of malleable iron or cast steel, bolted or riveted to the framework. If
required, these castings can be replaced by mild steel and thereby cut out
castings altogether. The sides of the framework are of flat section, 1/8 inch
thick mild steel riveted to short ties of angle iron of 2 inches by 2 inches by
¼ inch section. In the new low type conveyor, each side frame measures 6
feet between centres and weighs 36 lb., while the cradles, complete with
rollers, weigh 62 lb. The parts are light, flexible and strong. The capacity of
the conveyor is 40 tons per hour maximum rating.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Reis, Albert V. | | Mining Engineer | |