8th June 1927, Page: 360, Column: 2
Rock Dusting And Fires
In a report issued by the United States Bureau of Mines, H. C. Howarth
and H. P. Greenwald describe preliminary tests at the Bureau's
experimental mine, under the general supervision of G. S. Rice, chief
mining engineer, to determine whether rock dust may be used to extinguish or
control mine fires. The dust used for application by hand was made from draw
slate taken from the experimental mine. This draw slate was crushed in a
hammer-type crusher fitted with 1/16 in. by 2in. slotted screens. A sizing test
of the dust showed 96.5 per cent. through 20-mesh, 69.4 per cent. through
48-mesh, 46.2 per cent. through 100-mesh, and 33.5 per cent. through 200-mesh.
The dust contained about 10 per cent. combustible matter, 2 per cent. moisture,
and 88 per cent. ash. The dust used in the rock-dusting machine was made from
shale taken from a bed about 60ft. below the Pittsburgh coal bed at the
experimental mine. This dust contained about 2 per cent. moisture and 1 per
cent. combustible matter. A sizing test of the dust gave 99.9 per cent. through
20-mesh, 95.8 per cent. through 48-mesh, 79.6 per cent. through 100-mesh, and
62.7 per cent. through 200-mesh. The dust was applied either by means of a
modern rock-like distributor having a movable discharge pipe or by shovelling
it on the fire by hand. The following are the conclusions arrived at: (1) The
results of the tests indicate that rock dust may be used effectively for
controlling fire when it may be approached and the dust applied direct. This
applied to fires on the floor or in any position where it can be covered with
dust. The quantity of dust required will depend upon the area of the fire. (2)
The tests indicate that a blanket of dust 2in. thick will be sufficient to shut
off the air supply completely and smother the flame. (3) One of the chief
advantages that rock dust has over water is that there is no steam to add to
the discomfort of the firefighters, and it does not evaporate and permit the
fire to burn up again. (4) In the case of burning gas, the flame may be
gradually concentrated and finally extinguished when the gas is coming from the
bottom of any place that can be covered with dust. (5) When the gas flowing
from drill-holes at the working faces of coal mines has been ignited the flame
may easily be extinguished with a shovelful of rock dust, if the dust is so
directed that it will momentarily interrupt the flow of gas. (6) In the
experiments with the rock-dusting machine, the intensity of the fire was
reduced in one or two cases, but the results were not as encouraging as had
been expected. The best results with the machine were obtained when the
ventilation was reduced to almost zero. Satisfactory results may be obtained
with the machine in the case of a fire in a dead end, as at the face of an
entry, if the machine is placed at the last cut-through and the stream of dust
directed toward the fire. This experiment could not easily be made without
exposing the men engaged to considerable danger; also, there was the
possibility of starting a fire that would get beyond control, resulting in
considerable damage to the mine.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Greenwald, H. P. | | U.S. Bureau of Mines | |
| Howarth, H. C. | | U.S. Bureau of Mines | |
| Rice, G. S. | | Chief Mining Engineer | |