|
23rd April 1927, Page: 310, Column: 1 Inflammability Of Coal DustsCoal dust is inflammable, but its inflammability can be reduced by intermixture with incombustible dust. Various coal dusts, however, have different degrees of inflammability, and the quantity of incombustible dust that requires to be added to a particular coal dust in order to render the mixture incapable of propagating flame consequently varies. The inflammability of coal dust is dependent upon a number of factors, and several laboratory methods have been proposed for determining the relative inflammabilities of different coal dusts with sufficient accuracy to render extensive large-scale tests unnecessary. A paper by A. L. Godbert entitled "Laboratory methods of determining the Inflammability of Coal Dusts" (Safety in Mines Research Board, Paper No. 31, H.M. Stationery Office, price 1s. 6d. net), contains a historical survey of the subject, a review of the influence of various factors on the inflammability of dust clouds, and a discussion of the relative inflammabilities of coal dusts. It indicates the lines of further researches now proceeding in the Board's laboratories at Sheffield, and should be regarded as preliminary to a full report on the results of those researches. The following abstracts may be of more than passing interest:— Research on the inflammation of dust clouds has been conducted during the last half century by a number of workers, the primary object of whose researches has usually been the prevention of dust explosions in coal mines. Early observations by Buddle (1803) and Faraday and Lyell (1844) had drawn attention to the possible participation of coal dust in colliery explosions, but to Galloway (1876) is due the credit of impressing upon mining engineers the potential danger of accumulations of coal dust. Galloway's researches, which extended over a number of years, led him to the conclusion that a cloud of dust in air, without the presence of firedamp, could produce a violent explosion, and that coal dust was, in fact, responsible for many of the most devastating mine explosions. His insistence upon this belief, in the face of considerable opposition, though he was strongly supported by two of H.M. Inspectors of Mines, the brothers W. N. and J. B. Atkinson, led ultimately to the experiments of the Mining Association of Great Britain who, in 1908, installed a steel gallery at Altofts in which explosibility trials could be made on a large scale. The gallery was subsequently transferred to Eskmeals, where the experiments were conducted by the Explosions in Mines Committee of the Home Office. Similar experiments have been carried out in France, at Lievin and subsequently at Commentry ; and in America in an experimental coal mine at Bruceton, Pennsylvania. These large scale explosibility trials have provided a fund of information with respect to the initiation and development of a coal dust explosion and have enabled remedial measures to be formulated which, when adopted, have almost eliminated disastrous dust explosions in coal mines. The remedy, which usually takes the form of sprinkling the roadways and galleries of a coal mine with stone dust so that the coal dust lying in the mine is always mixed with at least an equal weight of incombustible dust, is, however, an empirical remedy and recent experiments have shown that with some coal dusts the amount of stone dust to be added to render them inexplosible may be so great as to make the remedy impracticable. At present, in order to determine the amount of stone dust required to render any particular coal dust inexplosible it is necessary to submit it to trial in a gallery of large cross-sectional area.. There are practical objections to performing a series of explosibility trials on coals from each of the workable seams of Great Britain. Such a series would take many years to complete, and the aggregate cost would be high. For these reasons, it is desirable that means should be devised whereby the degree of inflammability of any particular coal may be measured relative to some standard coal or series of coals in a laboratory apparatus. In order that this may be done, it is necessary to estimate the influence of any set of conditions likely to arise in a coal mine, but difficult to reproduce in a laboratory apparatus. It is also necessary to discover, if possible, to what property or properties of a coal the inflammability of its dust may be attributed. The report aims to co-ordinate knowledge of the influence of various factors on the inflammability of coal dust, and to suggest means whereby the relative abilities of different coal dusts to give rise to explosions in mines may be determined, Without recourse to large scale explosibility trials. In the historical survey with which the report opens, attention has in consequence been concentrated on laboratory researches. Part 2 of the report discusses the influence of various factors on the inflammability of dust clouds, namely, (a) inflammation of coal dust clouds ; (b) density of the dust cloud ; (c) fineness of the dust particles ; (d) chemical constitution of the dust; (e) effect of added incombustible matter; (f) character of the atmosphere. From Part 3 on the relative inflammabilities of coal dusts we quote as below, concluding with the summary :— The relative inflammabilities of coal dusts have been determined by some workers by the ease of ignition of the dust clouds and, by others, by the ease of flame propagation through them. Many so-called "ignition" experiments, such as the determinations of relative ignition temperatures, have already been questioned on the grounds that there is no clear differentiation between ignitibility and ease of flame propagation. The ease of the propagation of flame through a suspension of dust in air, as measured by the speed of the flame, is not necessarily related directly to the ease of ignition of the dust, as determined, say, by its relative ignition temperature. It is not unlikely that the speed of the flame is partly governed by the ignition temperature of the dust under the conditions of the experiment, but of greater importance are, probably, the heat of combustion of the dust and the rate of its combustion. A dust cloud may, therefore, be difficult to ignite and yet, when flame propagation is assured through it by an adequate igniting source, it may occasion explosions much more violent than those of more easily ignitible dusts, if, for examine, its heat of combustion is high enough to compensate for its high ignition temperature. Thus, the Explosions in Mines Committee found that anthracite and wood charcoal could only be ignited by an exceptionally strong source of ignition. Nevertheless, having a high calorific value, these dusts exploded with much more violence than a more readily ignitible bituminous coal dust. The relative ignition temperatures were :— Bituminous coal dust: 560° C. ; anthracite : 780° C. ; charcoal: 750° C. The relative speeds of flame in different gaseous mixtures can be characterised by the speed with which flame travels along the first portion of a tube containing the mixture, open at the end at which the mixture is ignited and closed at the other end ; this speed is called the "speed of uniform movement." Under similar conditions of experiment it is doubtful if any truly characteristic flame speed could be measured in a dust suspension ; at any rate, our present technique does not allow us to do so. Nor, in fact, is it possible to determine in the laboratory with any degree of certainty any truly representative measure of the speed of flame in a dust cloud. Investigation of the problem is hampered at the outset by the influence of its constitution. Fineness is cited as an uncontrollable factor, since it is controllable only to a limited extent. In order to ensure a satisfactory propagation of flame through a coal dust cloud under conditions simulating those obtaining in the gallery of a coal mine (or, for example, in the steel gallery at Eskmeals or in the experimental mine of th" U.S. Bureau of Mines), the major portion of the coal dust should be capable of passing through a 200 mesh, I.M.M., sieve. At best, sieving is a poor measure of the fineness of a dust, whilst for the determination of ultimate fineness, that is of the degree of fineness of the dust which passes a 200 mesh I.M.M. sieve, it is wholly inadequate. Another uncontrollable factor is the concentration of the dust cloud. It is difficult to ensure a uniform suspension of the dust, and perhaps still more difficult to prevent the deposition of dust from suspension. Even under rigidly standard conditions, such measures as might be adopted to overcome these disturbing influences would militate against precision. However satisfactory, therefore, the speed of propagation of flame might be as an index of the relative inflammabilities of coal dusts, the difficulties attending its measurement in the laboratory leave it desirable to choose, if possible, some other index. The index of the inflammability of a coal dust cloud has been fixed in large scale explosibility trials as that amount of inert dust which must be added to a coal dust to prevent its ignition by a standard igniting source. The practical importance of this criterion is obvious. The ultimate aim of the investigation of the inflammability of coal dust is the prevention o£ coal dust explosions underground, and the means adopted to accomplish this in practice is the addition of inert dust to the coal dust lying on the roadways of a mine. The criterion adopted in large scale explosibility trials is, therefore, immediately applicable to mining practice. For this reason the criterion adopted by the Bureau of Mines for laboratory determinations of the relative inflammabilities of coal dusts has also been the determination of their inert dust limits, that is, the percentage of inert dust in that mixture of inert dust and coal dust which is just "non-inflammable" under given conditions of experiment. Under different conditions of experiment the inert dust limit of any coal dust has different values, but provided that the inert dust limits of a series of dusts are determined under one set of standard conditions, there is reason to believe that, if the experimental method is suitably chosen, the values found are truly characteristic of the relative inflammabilities of the coal dusts under other conditions, just as the speeds of uniform movement of flame in different gaseous mixtures, determined under one standard set of conditions, are truly characteristic of the speeds of flame in those mixtures under other conditions. The method which is being developed by the Safety in Mines Research Board consists, briefly, of determining the amount of inert dust required in a mixture with coal dust to suppress the ignition of the dust. The experimental method is so arranged with respect to the conditions of temperature and blast pressure that the relative results with different coals are applicable to those coals under all conditions of temperature and blast pressure. The criterion adopted is not the production of a flame of given, and arbitrary, volume, but the production of no flame at all. The method has these advantages : 1. The results can be duplicated with extreme accuracy. 2. No arbitrary measurements are involved. 3. The results are independent of the furnace temperature and the blast pressure. 4. The method measures the relative ignitibilities of a series of coals and provides direct information with regard to the measures to be taken to prevent the ignition of the dust in the mine from which each coal is taken. Covering the present inquiry the following summary is given :— 1. It has been shown that, however the inflammability of a given coal dust is measured, it will depend upon a number of factors, the chief of which are :—(a) The concentration of the dust in the cloud. (b) The fineness, or rather the surface area per unit mass, of the coal, (c) The presence or otherwise of added incombustible matter, (d) The chemical composition of the coal, (e) The nature of the atmosphere in which it is inflamed. 2. There are several possible methods of determining the relative inflammabilities of coal dust clouds, namely :— (a) To determine their relative ignitibilities by measuring their ignition temperatures, (b) To measure the speed of flame in clouds of different dusts under standard conditions of experiment, (c) To determine the amount of inert dust which must be mixed with the coal dusts to render them non-inflammable. 3. The adoption of the ignition temperatures of coal dust Clouds as the measure of their inflammabilities is unsatisfactory because :— (a) Different methods of measuring the ignition temperatures suggest different orders of inflammability in a series of dusts. (b) Dusts with a high ignition temperature (e.g., anthracite and charcoal) may give rise to more violent explosions than dusts with lower ignition temperatures. 4. The determination of the speed of propagation of flame in clouds of the dust is a more satisfactory index of inflammability, but presents experimental difficulties, particularly on a small scale. 5. The most satisfactory method of comparing the relative inflammabilities of dusts is probably the determination of the amounts of incombustible dust which must be added to prevent their inflammation. The method has the advantage that the results are immediately applicable to the prevention of explosions in coal mines. 6. Previous methods of determining the relative inflammabilities of coal dusts depending upon the amount of inert dust required to render a coal dust non-inflammable are open to certain objections.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||