29th January 1927, Page: 219, Column: 1
The Chemist In Relation To The Mining Engineer
By Neville Simpkin, M.Sc.
It is only within the last few years that the chemist has become directly
associated with the mining industry. Mining has always been looked upon as
essentially an engineer's task, and while it will always remain so, there are
ways in which a chemist can be of use to the community provided he is given the
opportunity.
Composition, Working, and Disposal of a Seam. — As is well known,
seams vary very considerably among themselves, and also through the section
from top to bottom of one seam. The time has passed when coal was merely mined
and sold without special precaution being taken as to the exclusion of dirtier
bands, separation of the seam into special grades, screening or purification.
To-day the demands of various chemical and metallurgical industries as well as
boiler and power houses necessitate the marketing of carefully graded products.
Buyers and consumers are taking more care over what they buy ; ash and moisture
contents, calorific value, and so forth, are taken into account; whilst the
coke oven manager, the gas engineer, and the chemical engineer demand coals
containing a minimum amount of sulphur, phosphorus, alkalies and salt. In order
to have available the above information, chemical analysis is imperative. A
systematic chemical investigation of a seam will indicate the variation in ash,
calorific value, sulphur, phosphorus, caking properties, melting point of ash,
etc., of the different horizons of the seam. With a knowledge of these, it may
in certain cases be profitable to work a seam in a different manner to obtain a
purer coal for a special purpose. As an example, it frequently happens that the
sulphur is not evenly distributed and the elimination or separate filling of
part of the seam may very much improve the product.
Washing tests on coal yield very valuable information. As a rule both sulphur
and ash contents vary considerably in the different sized products from one
seam, and more attention could be paid to this subject with advantage. This
applies particularly to the purification of the finer sizes of coal from ¾
inch downwards. Washing tests indicate to what extent the ash content can be
improved by washing sized coal. The effect of washing upon the melting point of
the ash, and also upon the sulphur content, can also be determined.
Laboratory experiments indicate the optimum results which can be obtained, but
an actual washer will not operate to such a high efficiency. Unless actual
running tests on the washer are performed, the engineer has no indication of
the efficiency obtained. Many types of washers contain several separate wash
boxes, operating either on similar or different sized coal, the washed products
being often mixed again. One or more boxes due to faulty adjustment may allow a
large quantity of coal to pass away with the dirt or not remove the dirt
satisfactorily. It is only chemical analysis which will indicate the efficiency
of the washing in each separate box. Washers have been known to pass 10 to 20
per cent. and even more of coal into the dirt. As an example, felspar washers
in which there is insufficient felspar will allow coal to travel away with the
dirt. A systematic test taken over a period on the various products from the
boxes will indicate such points and show whether the washer is operating
satisfactorily.
Gas and Mine Dust Analyses. — It should not be necessary to
mention the importance of a knowledge of the variation and composition of the
air in various parts of the pit. It is recognised that an experienced man can
with the aid of an oil lamp determine roughly the amount of methane present,
but the figure obtained must only be taken as very approximate. It does not
indicate gradual changes, nor the amount of oxygen and carbon dioxide. Chemical
analysis will show whether an increased evolution of carbon dioxide or methane
is occurring together with variation in the oxygen content. The relationship
between the production of carbon monoxide and heating in the goaf is of extreme
interest. Carbon monoxide is formed by the incomplete combustion of
carbonaceous matter, and hence the presence of carbon monoxide in mine air must
be regarded with suspicion. Mine air samples should be analysed frequently and
systematically. The analysis of mine dusts might be mentioned. The intelligent
interpretation of the results will usually lead to considerable economy in the
use of the dust.
Water Supply. — Water supply at a colliery is often a matter of
great difficulty owing to the situation of the pit in relation to surrounding
water supplies. There is a tendency to use a water merely because it looks
good. On no account should a water be used for boiler feed purposes without
previous analysis. This will indicate whether it is totally unsuitable, or
whether it should be softened before use.
Surface waters in the neighbourhood of collieries are usually badly
contaminated by drainage from pit dumps. Such waters are frequently acidic and
should not be used. Pit waters are also very liable to possess acid properties
and it may be necessary to examine a great number of different sources of
supply to find the most suitable.
It would appear that the importance of a pure water supply for steam-raising
purposes is not sufficiently realised. Allied with this subject is the question
of corrosion and deposit formation in subsidiary plant, such as economisers,
superheaters, condensers, heat exchangers and deposits in steam engines. A
careful examination of the corroded part or the deposit coupled with an
investigation of the actual conditions (this latter being of almost greater
importance but useless without the former) will usually point out the cause of
the trouble.
Turning to the supply of water for washers, an acid water will damage the metal
work, whilst if the coal is being used for coke manufacture the water must be
examined for the presence of alkalies, chlorides, etc., which cause corrosion
of the coke-oven walls. At many collieries, washery water has to pass through
the plant several times, whilst if run direct to waste, the question of
contamination and pollution of streams arises. Control should be kept of the
quantity of matter in suspension, since if it becomes excessive the fine dirt
tends to deposit on the washed products.
Lubrication. — Oil and grease consumption constitutes a large item
in yearly expenditure. Price alone should not be the determining factor when
purchasing supplies, and the chemical analysis of oils and greases greatly
assists in determining lubricating value and enables a comparison to be made
between various grades.
Miscellaneous. — There are a variety of other ways in which the
chemist can assist in general colliery control. As examples mention might be
made of the amount of oil in condensed steam, the general testing of various
supplies, e.g., oils, brattice cloth, accumulator acid, etc., control of
water-softening plant and boiler installations generally; the composition of
shales, especially if used for brick-making.
The Chemist at the Colliery. — A word should be said about the
position of the chemist at a colliery, his relationship to the staff there, and
also to the central laboratories. One man will have sufficient routine work to
keep him employed almost the whole time, and consequently the advantage of a
central laboratory becomes apparent. Furthermore, a colliery chemist tends to
become isolated owing to his position, and it is of great advantage to him to
come into contact with others engaged on somewhat similar work since it enables
a change of ideas to take place. A problem should never be put to a chemist
without giving him as much information about it as possible and letting him see
the conditions for himself. He will thus have an opportunity of collecting data
which may materially assist him and which otherwise might not be observed. The
chemist should not be confined within the four walls of his laboratory. To
ensure satisfaction co-operation is necessary between the colliery chemist and
the mining engineer, and if the latter is to obtain the greatest benefit, a
fully qualified and experienced chemist is essential. An ideal system would be
the employment of a chemist at each colliery and a central laboratory for a
group of collieries where all problems could be referred. The staff of the
central laboratory would consist of specialists in the various branches of
chemistry dealing particularly with colliery work, and these would be in direct
touch with the chemists at the collieries and with the work there, and be able
to visit any colliery as required. The chemists at the collieries would visit
the central laboratories at regular intervals. This system is aimed at by the
Association, and if larger, the scheme could be further extended.
* Extracts from paper describing the work of the Lancashire and Cheshire Coal
Research Association, presented at the January meeting of the Manchester
Geological and Mining Society.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Simpkin, Neville | | | |