9th October 1926, Page: 90, Column: 2
Low Temperature Carbonisation
Before the South Wales Institute of Engineers in a paper on Low Temperature
Carbonisation, Mr. O. J. Parker considered the cases of lump coal and
smalls. In the case of lump coal the cost of plant for a daily production of
100 tons can be put at about £21,000. The weight of raw coal necessary
per ton of carburite is from 1.4 to 1.6 tons, depending on the volatile
content. The amount of tar produced from various high-grade brown and black
coals suitable for carburisation is between 7 and 10 per cent. of the initial
weight of fuel. With regard to the valuation of the carburite tar it is of
importance to note that both the benzene and the petroleum products of the tar
have the smell, specific gravity, and other properties of the corresponding
earth oil derivations. The running expenses of a 100 ton plant would be about
4s. 6d. per ton, when working fully. This figure includes interest and
amortisation of capital cost. In the case of smalls the raw material must be
briquetted before carburising, but this is not the main economical purpose of
the process. The extra expense involved, however, can be borne, as the smalls
dealt with have only a very low commercial value in consequence of the
restricted demand for this material. The ordinary method of briquetting coal
with pitch as a binder is not used, for several reasons, both technical and
economic. Numerous trials have proved that only the briquettes produced by the
colloidal process are suitable for subsequent carburisation. Whereas only
non-caking or slightly caking coal can be carburised successfully in the lump
form, any fine coal, whether caking or non-caking, can be transformed through
the carburisation of colloidal briquettes into a solid smokeless fuel. The use
of non-caking fine coal demands the addition of a small quantity of caking fine
coal, which in most cases can be obtained cheaply as washed duff or coal dust.
By this method it is possible to produce smokeless carburite briquettes of
sufficient hardness from non-bituminous or even from anthracite dust.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Parker, O. J. | | | |