|
11th September 1926, Page: 57, Column: 2 American NotesStone-dusting. At a recent meeting of a section of the American Institute of Mining and Metallurgical Engineers, a paper entitled "Rock Dusting in West Virginia" was presented by R. M. Lambie and Gordon MacVean. The authors say that in order to properly rock dust a mine, the following steps should be taken :— (1) Clean up all the haulage entries, so that they will be as free from dust as possible. The less coal dust present the less rock dust necessary to obtain the proper proportion of incombustible material in the mixture. It is easier and more economical to load it out before rock dusting. (2) The second step after cleaning up, is to make tests and determine the amount of incombustible matter that is in the remaining dust in order to determine approximately, how much rock dust has to be added to the different sections to bring the incombustible contents up to the percentage that is required for the particular seam which is being mined. Rock dust sampling and analysing outfits are on the market for this purpose. (3) The next operation is to coat all the entries with a sufficient amount of rock dust to bring the incombustible content to the required percentage. This can best be accomplished by means of a mechanical distributor having a flexible nozzle under the control of an operator. It is desirable to obtain a uniform application. After having dusted, it is wise to make a systematic sampling of the mine taking the samples about 1,000 feet apart. Samples should be taken thereafter on an average of about once a month. (4) Following this should come the installation of the rock dust barriers. If all the haulage entries are properly dusted, the dusting being kept up to the last break through, and the trackless entries protected by rough barriers, absolute protection from the propagation of a coal dust explosion should be obtained. Open Light Hazards. Open lights have been the probable initial cause of the death of 3,361 men in U.S. coal mines during the past twenty years. The accidents responsible for these deaths included six fires and 112 explosions, according to O. P. Hood, of the Bureau of Mines, Department of Commerce. To start an explosion or fire requires a source of ignition, and the Bureau of Mines believes open lights are so much of a hazard that their entire elimination from all coal mines is warranted. Several hundred thousand open lights are daily carried into coal mines in the United States, each lamp being a menace to life and property through fire or explosion. The continued use of open lamps is due to many causes, but the reasons for their use grow weaker as closed lights become more highly developed and the hazard of open lights becomes more evident. The mine that has no gas to-day may have gas to-morrow. Gas and coal dust are present in most coal mines. The distinction between a gaseous and a non-gaseous mine is one of definition and degree, rather than a matter of fact; consequently a reasonable condition of safety may quickly change to one of danger. If a mine or a room in a mine suddenly becomes gassy, open lights are a ready source of ignition. They have been responsible for many mine fires. It is for such reasons that the Bureau of Mines has aided the development of safe electric lamps, marks them as approved, and advocates their use in all coal mines.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||