|
28th August 1926, Page: 33, Column: 1 Coal DustIn examining the problem of coal dust explosions the most important factors, with respect both to the ignition of coal dust and the propagation of flame in a dust cloud, are the degree of fineness, the shape and the distribution of the particles of dust in the cloud, and the particular physical quality involved in the Specific surface of the dust, i.e., the ratio of surface to mass in the particles of the dust. The merits of the several methods which can be used for determining the specific surfaces of dusts are discussed in a paper by E. F. Greig entitled "Some problems connected with the determination of the fineness of coal dust." (Safety in Mines Research Board Paper No. 25, H.M. Stationery Office, price 1s. net.) As the result of the discussion it is concluded that sieving methods are not sufficiently accurate, that air elutriation methods provide means of obtaining grades of dusts of definite ranges of specific surface for the purpose of correlating specific surface and degree of inflammability of a dust cloud, that by a combination of elutriation, sedimentation and microscopic examination, it is possible to grade the specific surfaces of dusts, and that other methods, of a more empirical nature, may be found useful for rapid determination and field use. Defining the programme of work the Author says :— The first problem on taking up a programme on "the fineness of coal dust" will be to define the goal aimed at, for on that definition must depend the character of the work. What is "fineness" ? What is the object of measuring it ? The second question is the more important one. Since all the Board's researches are directed towards safety in coal mines, the answer must be in the form that will most readily indicate the degree of danger that mine dusts afford. Coal dust is most dangerous when in the form of a cloud. True, it may smoulder when in a heap, and the combustion may then spread, but its most dangerous effects are produced when the combustion of the dust occurs in the cloud raised after the passage of the "shock wave" which travels in advance of the explosion front proper. The action of the wave is exemplified by what occurs when a train passes rapidly through a railway station. It will be noticed that any waste paper lying about is lifted into the air behind the "shock wave," the rear edge of the paper rising. The wave by its compression hits the paper down and compresses the air underneath, but under the slight vacuum that follows the passage of the wave over the sheet of paper, the air beneath it expands, causing the sheet to lift a little at the rear, when it is caught up by the rush of air above it. It is conceivable that a piece of paper would remain undisturbed on the ground with a wind blowing over it at a velocity of a hundred miles an hour, provided that the wind was perfectly steady and had risen gradually ; whereas the slightest sudden gust of wind would lift the paper up. Something of the same kind must happen during a coal dust explosion in a mine. What lifts the dust off the roadway is, in effect, the air trapped within the deposit, and one factor that renders the dust dangerous is the amount of air that is thus lying imprisoned between the dust particles lying on the roadway, the timbers and the walls of the mine. For when a pulsating wave passes over the dust, the initial part of the wave causes a compression of the trapped air, whilst the release of pressure that follows gives the air below the dust a chance to expand. It is to be noticed that, with a continuous current of air of constant velocity, no dust will be raised from a road. It is the gusty wind that raises a cloud. This is due to the fact that in a pulsating fluid the pressure varies inversely as the velocity. Where the air moves fastest, there the air caught in the pile of dust expands most. Once a particle is brought into the path of the moving air, if large it will behave as an aerofoil (like an aeroplane wing), or, if small, it will behave as the disperse phase of an aerosol (like dust particles in smoke). The amount of air trapped within a given volume of dust is related in some way to the latter's "fineness." The more finely a dust is ground, the more air will it entrap. These facts suggest that it might be possible, where large accumulations of dust exist, to diminish the danger of cloud formation by displacing the entrapped air, not by wetting the top layers but by allowing a liquid to percolate from below or from one side. Soaking a pile of dust from the top merely drives the air further down into the mass, under greater compression, and may keep it imprisoned underneath. It is therefore of considerable interest to the worker on safety in mines that bulk-density measurements should be made on coal dusts. However empirical they may be as a measure of the fineness of the dust, they are a measure of the air contents of the sample of dust considered, and, as such, a measure of the cloud-forming possibilities of the deposit. The cloud has started forming by the expansion of the entrapped air, but the degree to which this expansion will form a cloud depends on the terminal velocity of the dust particles. The terminal velocity of a particle in a fluid is the limiting velocity at which the particle considered will sink in the quiescent fluid, such as water, oil, air, methane, or firedamp ; or conversely, it is the lowest upward velocity of the fluid which will keep such a particle in suspension. As is well known, when a particle falls slowly in a fluid, whether a gas or a liquid, the solid is covered by a film of fluid that is motionless with reference to the solid. This film drags another along with it, but at a slightly different velocity ; the second film drags a third, and so on, each successive film travelling a little more slowly than the one nearer the solid, until the velocity, of this partial gas envelope is nil. Between each pair of films an element of viscous force is acting, the stress being taken, in the example under consideration, by the quicker moving one, and passed on through it to the next more rapidly moving film, until it is taken up by the solid itself. The strain, which is resisting the difference in motion between the gas films, opposes the motion; of the particle, and the force of gravity has to work against it. When the total retarding strain is equal to the gravitational pull, the particle is moving at its terminal velocity. Now it is fairly evident that this retarding force, due to the viscosity of the fluid is proportional to some function of the size of the particle, while the gravitational pull is proportional to its mass. The terminal velocity, therefore, will be a function of the ratio of these two forces.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||