|
8th May 1926, Page: 332, Column: 2 Thorne Colliery AccidentThe report of Major H. M. Hudspeth, Divisional Inspector of Mines, on the accident which occurred at the No. 2 shaft of the Thorne Colliery, Yorkshire, on March 15th has now been issued. It will be recalled that six men lost their lives owing to the breaking of a capstan engine and the consequent fall of a sinking scaffold, on which the men were working, to the shaft bottom. When the capstan engine broke, the ropes supporting the scaffold were torn out of the engine and went with the scaffold to the bottom. After a detailed examination of all the circumstances and the gear involved, Major Hudspeth says the only question to be settled is whether the reverse rotation of the drums was initiated by the capstan engine or was caused by the pull or the scaffold rope. Discussing the latter possibility, he considers the load involved and the strain necessary to break the part of the engine which gave way, and says it is inconceivable that this occurred. The Inspector proceeds: "The alternative is that the engine-driver unwittingly put his reversing lever into the 'lower' position. The drums would then be driven against the pawls, and as the latter did not give way would tend to rise. This, I hold, they actually did, until by breaking the pedestal bearings they were free from the worms, and at once began to rotate due to the weight of the scaffold and ropes, etc., assisted at the commencement by the engine. "A steam pressure of 150lb. per square inch on a 14in. piston is equivalent to a load of 10 tons. The total gear reduction between engine and drum was 90. Allowing a very liberal margin for friction and loss, the pressure which the engine could exert against the bearings under the circumstances given above would be very considerably in excess of the load due to the weight of the scaffold, ropes, etc. "The pawls were so fitted that in the event of the engine being driven against them disaster must result. It would appear therefore that pawls should not be fitted on worm-driven capstan engines unless they can be so arranged as to avoid such an occurrence. The difficulty of ensuring this is such that, in my opinion, pawls should not be used."
|
|||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||