13th February 1926, Page: 227, Column: 2
Lubrication Of Colliery Machinery
An interesting address, illustrated by lantern slides, was given
before the January meeting of the Past and Present Mining
Students' Association at the Wigan Mining and Technical College,
by Mr. Aubrey B. Smith, M.I.Mech.E., M.I.Mar.E. The lecturer
gave a review of the various prime movers and other machinery
met with in collieries, and emphasised the punishment to which
lubricants are subjected in modern high speed machinery generally,
demonstrating this, particularly in regard to steam turbines,
and various types of steam engine cylinders, including the uniflow,
by the help of lantern slides. Attention was specially drawn
to the care needed in the lubrication of steam turbines, and the
necessity that the lubricant for this class of work should readily
separate from water and impurities under the exacting conditions
met with in a circulating system. Mention was made
of the desirability of there being a large amount of oil in circulation,
and the benefit to be derived by maintaining the condition, and
thus prolonging the life, of the oil, by drawing off quantities for
centrifugal or other suitable treatment in those cases where there
was no purifier actually in circuit with the system. The lecturer
pointed out that where water gained access to the lubricating system
it should be drawn off at frequent intervals so that undue punishment
of the oil might be avoided, and a device for achieving this
satisfactorily was described in detail, it was explained that to
determine the source of water getting into the system it should
be chemically examined with a view to ascertaining whether it
came from the steam side or the oil cooling arrangements.
The Selection of Oils.
When selecting lubricating oils for use in a steam engine
cylinder, the lecturer stated, consideration should be given to the
various types of valves, slide, corliss, poppet and piston, in conjunction
with steam temperature and pressure. The necessity
was also pointed out for differentiating between superheat, dry
and wet steam, and for bearing in mind the load conditions of
the engine. The various means of introducing the lubricant
to steam cylinders were explained by the lecturer, these being
the indirect, or atomising, method; the direct method, whereby
feeds are taken to definite moving parts; and a combination
of the two systems.
Cause of "Carbon Deposits."
So-called carbon deposits on the infernal working surfaces of
steam engines, internal combustion engines, air compressors, etc.,
the lecturer pointed out were often due either to unsuitable oil,
or, even in the ease of the oil being suitable, to lack of feed control,
and a modern mechanical lubricator which gave complete control
of the oil feed was illustrated and explained. The rougher
machinery in colliery practice was also considered at some length,
and the necessity for the use of grease as a lubricant under certain
conditions where there were dusty surroundings was shown.
Mention was made of the importance of adequately taking care
of the lubrication of colliery trams, and the necessity of remembering,
when selecting a lubricant for this purpose, the conditions of
load on the tram axles, as on the uninterrupted working of these
units mainly depended the output of the colliery.
On the whole the lecturer dealt with the question of lubrication
from the standpoint of field experience in the running of industrial
machinery rather than from the chemical and physical characteristics
of lubricating oils.
An interesting discussion followed.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Smith, Aubrey B. | | | |