6th December 1925, Page: 153, Column: 1
Miners' Electric Safety-Lamps
In his paper before the Batley and District Mining Society,
Mr. Edwin Lyon said that a miner's electric safety-lamp should possess
certain characteristics which might be set out as below: (1) Portability,
(2) strength, (3) reliability, (4) safety, (5) low upkeep cost,
(6) as high a candle-power as possible. Of these points perhaps
the cost of upkeep has been given too much prominence of late.
The cutting down of upkeep costs has in some instances been taken
so far as to reduce the efficiency of the installation for the sake
of a fraction of a penny in the weekly costs per lamp. Spares
have been cut down to a minimum, at times being foreign parts
of doubtful quality, and the installation starved until it is unable
to operate efficiently and an apparent gain becomes an actual
loss. The three main essential components of a miner's electric
safety-lamp are the accumulator, the bulb and the casing. Regarding
the ever-green question of gas detection by an electric
lamp, there appears to be no dearth of ideas for the solution
of this vital problem. A lamp for this duty must be reliable,
simple, capable of being handled by the collier as easily as the
lamp he is accustomed to use. There is a lamp in existence, the
author proceeded to say, which approaches very closely to this
ideal. It is now undergoing severe tests underground, and so
far has justified the hopes of its sponsors. The principle on which
it operates is simple — an ordinary electric safety-lamp fitted
with a special well glass, carries above the bulb a small oil lamp.
By the provision of double gauzes at the top and bottom, the flame
is made quite safe. This lamp is lit by a platinum filament. For
general usage the ordinary electric bulb is used. When a test for
gas is to be made, the light is switched off, and by rotating the
lamp case, connection is made with an additional pair of contacts
on the insulating plate. Current from the accumulator then flows
up the supporting columns to the platinum filament, so igniting
the wick of the small oil lamp. The current is then switched off,
and the oil flame continues to burn, being regulated externally
by a variable sleeve over the wick tube. The test for the presence
of gas is carried in exactly the same way as when using an ordinary
oil lamp, and therefore requires no additional skill.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Lyon, Edwin | | | |