|
21st November 1925, Page: 139, Column: 1 Ollerton Shaft-SinkingAt the meeting of the Institution of Mining Engineers on November 4th, Mr. H. Eustace Mitton submitted a paper on "The Sinking of a Colliery in the East Nottinghamshire Coalfield." He mentioned that for many years the large coal companies in Derbyshire and Nottinghamshire have been engaged in further extending their interests by gradually prospecting for and developing the areas in the eastern portion of the coalfield. The sinking of the Ollerton shafts by the Butterley Company, Limited, commenced in November, 1923. The sinking method adopted was that of the Francois Cementation Company, Limited, of Doncaster, to a depth of 25 feet below the breccia, and by the Coal Company through the Coal Measures. The contract with the Francois Company called for all labour and material to he found by them, the Coal Company undertaking to pump any water met with up to 1,000 gallons per minute. The cementation process consisted as follows :— The two shafts were sunk by crane to nearly water-level at a depth of 35 feet. This was done so that the water-bearing ground beneath this level could be injected for a depth of 120 feet prior to putting in the headgear, foundations, and winding-engine foundations. The ground was injected by boring forty holes in the shaft at an inclined angle, and the chemical and liquid cement were forced under pressure through these holes into the strata. The pumping plant for dealing with the injection for these shafts comprised five 3-inch by 12-inch by 14-inch stroke and one 2-inch by 12-inch by 9-inch stroke high-pressure units. Of the five pumps three were used for cement, one for the silicate of soda, and one for the sulphate of alumina. The 3-inch pumps are made for a higher pressure than the 2-inch pumps. All the pumps are constructed to withstand a maximum pressure of 3,000lb. per square inch, but the normal working pressure is 1,250 lb. Ordinary steam piping is used in conjunction with the pumps. Following a description of the work that had to be done Mr. Mitton concluded by giving the time-table of the sinking as follows :— Entered upon the land, October 7, 1922. Commenced digging shafts to just above water-level (35 feet), and injected ground to 120 feet in the water-bearing strata, Feb. 20, 1923. No. 1 Shaft: Commenced sinking under the Francois contract on November 6, 1923. The depth sunk to 25 feet below the breccia is 992½ feet, and this depth was completed on April 7, 1925. The sinking then continued in the Coal Measures, and the Top Hard Seam was proved in No. 1 Shaft on August 4, 1925, at a depth of 1,578 feet, and in the No. 2 Shaft on September 23 at a depth of 1,585 feet.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||