30th August 1924, Page: 39, Column: 2
Compressed Air Plants
In a paper read at Glace Bay, Nova Scotia, Mr. James P. Cotter said that leaks are not the main cause of the loss of efficiency. The largest losses are the result of lack of proper engineering in laying out underground pipe lines, which, as a
rule, are not of sufficient capacity to transmit compressed air to the various working places without a very large loss. At mines equipped with a compressor plant of 5,000 feet to 6,000 feet capacity, an 8-inch main air line is usually installed. Pipe of
this size is too small, and will not carry the amount of air mentioned any distance efficiently, because there will be a loss of 2.46 pounds for every thousand feet. If the pipe-line is 5,000 feet long (a very common length in our mines) there will be a
total loss of 12.30 pounds. If this particular pipe-line was 12 inches instead of 8 inches, the friction loss would be reduced to 0.30 pound per thousand feet, or 1.50 pounds for 5,000 feet. The main lines are not the worst. It is in the branch lines
that the greatest loss occurs. It is not uncommon in a mine to find a headway, requiring from 1,000 to 1,200 cubic feet of air, piped with a 2-inch air line. The loss in such a case is very great-much over fifty per cent. A headway or section requiring
that amount of air should have a pipe-line at least 5 inches in diameter. As much care should be given to the lay-out and installation of underground pipe-lines as is given to the installation of the compressor itself. It is possible to design and lay
out an underground pipe system that will give a uniform velocity through the main line and branches, and get high efficiency. The result of such an installation would be a cheaper output, and contented officials and miners. A miner cannot possibly
produce a maximum output when operating a machine where pressure is reduced from 80 to 40 pounds, as a result of an undersized pipe line.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Cotter, James P. | | | |