|
21st November 1907 Bullgill CollieryFor many years the proprietors of this colliery have had great difficulty in contending with the enormous drainage of water into the workings, but they are now well on the way to surmount all obstacles. Not only is Bullgill pit in itself extremely wet, but it taps the water of Crosby and Rosegill pits, which have not been worked for some years. Consequently the strain on the Bullgill engines is much greater than is usually the case. In order to combat this, the owners are fitting up a Reidler force pump of Glasgow manufacture, which is calculated to force 600 gallons of water per minute to the surface. The pipes have been fitted in the shaft for some time, and a number of men are now busily engaged in preparing the engine-house at the bottom. They have had to make an excavation 37 feet high, 40 feet long, and 20 feet wide, and as this is almost completed, the engine will be laid down without delay. The whole of the construction is in the hands of Mr. Morton, chief engineer at Bullgill. The engine will be driven by steam, which will be conveyed from the surface in 4 inch pipes. Some idea of the power of this machine can be gathered from the fact that it must raise all the water which is supplied to meet by four Tangye pumping engines and numerous syphon pipes distributed through the pit. The present pumps will always be held in readiness in case of emergency. It is expected that the new engine will be in working order about New Year. The mechanical coal-hewers known as "iron-men" and now in operation, and are said to fulfil all expectations.
Newspaper transcript kindly provided by
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||