|
Ulverston AdvertiserArticle from the Ulverston Advertiser, 26th February 1857 The Opening Of the New Engine at Park MinesA short description of the "Burlington" engine may not be thought out of place: — It has a cylinder of 60 inches in diameter, with a stroke of 10 feet, is single acting, and applied for pumping water with a 15 inch pump from a depth of 80 yards; is, we believe a "Cornish Engine," that is, it embodies in its construction peculiar principles which give it a distinctive character and mane which it has long since obtained. Those principles involve a high rate of expansion of the steam — slow combustion of fuel — and the careful covering of all the surfaces of the boiler's cylinder, steam cases, and pipes &c., with non-conducting heating substances, to prevent radiation and condensation. At full power it is equal to 170 horses effective, with an expansion of steam of two-thirds of its stroke. At present it is "hot loaded" to quite one-third of its power; it lifts 60 gallons of water per stroke, and its speed, which can be regulated from 12 to 630 strokes per hour, is not above one-fifth of its maximum rate. This gives a large margin for the future expansion of the mine and those contingencies which are inseparable from mining. This unemployed latent power which costs nothing after the first outlay and does not deteriorate with age is always at hand when wanted. The supply of steam is generated in two boilers; each weighing about 11 tons and the working pressure is fixed at 30lbs per inch. The estimated supply of fuel at the present rate of working is about 12 cwt per day of 24 hours; and the proportions between the fire and flue or heating surfaces of the boiler will admit of a much greater consumption than this, without materially affecting an economical rate slow combustion. The engine and boilers are most carefully clothed, and, with the general arrangements and careful character of the construction, a good economical result will, it is hoped, be produced, and lead to an appreciation, and general introduction of this class of engine in a district where coal is almost as dear and its economical use as much a necessity as in Cornwall. The arrangements were under the supervision of Captain Hosking, and Mrs. Schneider christened the engine with the name of Burlington, by smashing a bottle of champagne over it as at a given signal, Mr. Loam, the engineer, set the machinery to work. (Abridged from original article)
Newspaper transcript kindly provided by
|
|||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||