|
Little is known of the methods of working and smelting used by the Romans, but it is probable that, even if stoping were not practised (as it is known to have been practised at Dolau Cothi in Carmarthenshire), they drove adits and took out as much ore as they could within the limitations imposed. Most of the Roman mining in this region, however, was probably by hushing, which, indeed, was described by Pliny in his Natural History. In the Middle Ages, and after, the general practice was to sink shallow shafts, drive adits, and work the available ore by stoping (usually overhand). Although legend ascribes the introduction of gunpowder into mining to Prince Rupert (at Ecton, about 1670), the older methods of breaking rock persisted until nearly the end of the nineteenth century, and the general acceptance of blasting was a very gradual process. The older methods were plug-and-feather, explosion by quicklime, and fire-setting. Plug-and-feather needs no description. In the second method, a row of holes was drilled, each hole filled with quicklime, and the end sealed with a perforated wooden plug. Water was poured through the plug and the expansion of the lime shattered the rock. There has been considerable evidence of firesetting in the Dales, and the following story is told by the late Edward R. Fawcett about his father, who had had an underground accident in Swaledale: "After recovering he started to work on trial along with James Kearton and Anthony Metcalfe on the north-east escarpment of Kisden Hill. They drove in a small adit level and found that the vein had been worked before from the surface by means of a shaft. They came into the' Old Man's' workings which were very interesting. All round the face of the old workings they found charcoal over a foot deep, the residue of wood that had been taken into the mine and burnt at the rock face to soften the rock by cracks so that it was easier to work with their primitive tools. Crude tools found were four wooden shovels and a wooden 'bearing barrow.'" Motive power for winding and pumping was supplied by the horse-gin, and then, where possible, by the water-wheel. This novelty was probably introduced into the Dales in the first half of the eighteenth century, and some of the great wheel-pits remain. Iron rails were first adopted in Smeaton's Nent Force Level at Nenthead, which, 4½ miles long (like the Blackett Level), was started in 1776 but was not completed for seventy years. Before that time the rails were of timber, and timber rails were used in Yorkshire even during the nineteenth century. The invention of the "water draught engine" for ventilation was due to the London Lead Company, and the accompanying sketch is made from a description by Dr. Arthur Raistrick. The inner cylinder, 23 in. in diameter, was given a plunger motion by a rocking beam worked in turn by a water-wheel. The outer cylinder, 28 in. in diameter, was filled with water to within a few inches of the rim. On the upstroke, air was drawn in through the two valves of the inner cylinder, and on the down-stroke the air was forced into the pipe and so into the mine. With an 11½-in. crank, each stroke of 23 in. gave 34½ gallons of air, and frequent minutes in the London Lead Company's records testify to the wide use and reliability of this ingenious appliance. Ore-Dressing Up to the end of the eighteenth century the only treatment, if any, received by the ore before going to the smelter was washing, and in the case of hushes even this would be unnecessary. But when the easier parts of veins were exhausted, and mining became deeper and harder, it became more and more essential to separate the ore from the gangue material (or "house" in the North). About the end of the eighteenth century the buddle first appeared in Britain, although its use in Germany had been described by Agricola as early as 1556. In the earliest form used in the North of England, an oblong floor of smooth flat stones was made, one of the longer sides being raised to give a gentle slope. The run-of-mine ore was placed on the stones and a strong current of water allowed to flow over it in the direction of slope. The water washed the material (incidentally making sorting easier), and a rough separation was effected between ore and gangue. The cleaned ore was then crushed by hand or by means of "buckers" before being sent to the smelter. In the nineteenth century the huddle gave place to the "grate" or coarse wet screen for preliminary washing and sorting, and the advent of the Blake crusher in this country in 1858 completely replaced the laborious work of the buckers. Almost simultaneously the shaking screen appeared, and then rollers for granulating and stamps for grinding (although the Cornish stamp had been in use from much earlier times). Circular buddies for the treatment of fines appeared about 1848, first in Cardiganshire, so that throughout the century the efficiency of extraction gradually improved. Spitzkasten, introduced from Germany, were first used in Britain at Allenheads Mine about 1857. In the third edition of Westgarth Forster (edited by W. Nail, 1883) there is the accompanying diagram of a contemporary crushing plant. Mine material was delivered from the truck A into the hopper S, whence it proceeded to fluted rollers. (Apparently the jaw crusher was not necessary in this plant.) The crushed ore then slid down two inclined planes w to the smoothfaced rollers driven by the cogs e, and proceeded thence to the next stage. The rollers were kept in close contact by the weights v, and the whole system was driven from the gear-wheel D keyed to the shaft of a water-wheel. Smelting For a long time the ore was smelted beside the mines, and throughout the Dales (and elsewhere) the earliest method of which traces remain was that of the "bayle hills" or "bole hills." A space a few feet in diameter was surrounded by a low wall of stones, with an opening facing west or south-west, the direction of the prevailing wind. A layer of brushwood and peat was laid inside, the ore heaped on top, and when a suitable wind was blowing the fire was lighted, the draught giving sufficient temperature to reduce the ore. The ore hearth (or Scotch hearth) was brought from Germany in the middle of the sixteenth century, first to Cumberland and then to the Dales. Although coal has been mentioned as a fuel, peat was always dominant, and the remains of the peat-shed at Old Gang can still be seen. Here, however, the peat was mixed with coal from Tan Hill Colliery. The reverberatory furnace was introduced in the middle of the eighteenth century, in Northumberland, but in Yorkshire it never entirely replaced the ore hearth, even though the Keldheads mill, at Wensley in Wensleydale (some distance from Keldheads Mine), with its cupola, became one of the finest smelters in the North. The building of long flues and the condensation of fume were adopted in the second half of the eighteenth century and early in the nineteenth, and the condensers bearing the names of Stokoe and Stagg were evolved by the London Lead Company at their Egglestone mill in Teesdale. At the time of Westgarth Forster (1821) it was customary to roast the ore as a preliminary to drive off sulphur and antimony, the roasting furnace being similar in form to the reverberatory furnace except for its flat base. We have already referred to the International Exhibition of 1862 in connection with Beaumont's mineral specimens, and at the same exhibition the great Thomas Sopwith exhibited a cake of silver extracted from Allendale lead by Pattinson's process. H. L. Pattinson, who discovered his method (by accident, it is said) in 1829, lived and worked in Newcastle-on-Tyne, a city which, as the nearest great industrial and academic centre to the Dales, and in spite of the growing supremacy of coal-mining, became closely associated with lead-mining, and the association, in a somewhat vestigial form, persists today. Conclusion Some of these concluding remarks will apply not only to the lead mines of the Northern Dales but practically to every metalliferous mining district of the United Kingdom. The factors that killed lead-mining were many, but, in brief, the most potent can be summarised as having been the exhaustion of known, proved, or more easily worked reserves, lack of capital for prospecting and exploration in depth, foreign competition, diversion of wealthy mining interests to overseas fields, and unfavourable metal prices, to say nothing of taxation and royalties. Nevertheless, although decline first set in about 1890, this Northern field was producing galena — not continuously, it is admitted — until 1943, when Sipton in Allendale finally closed down. Attempts and suggestions made in the last twenty years to revive British mining have never been fruitful. A committee formed in 1931 under Professor Henry Louis to investigate the possibilities concluded that if the depression of the time continued indefinitely it would be futile to consider revival of the mining of lead, zinc and tin, but the committee felt that the depression would not be prolonged and it was "reasonable to anticipate a substantial revival in the near future." There was a little revival, of course, but not of a "substantial" nature. In the 'thirties several original papers on different aspects of British lead-mining appeared, and at the end of 1940, when the need for metals had rather eclipsed economic considerations, came the paper by Professor W. R. Jones which started a long and lively discussion. On August 2nd, 1946, Mr. Shinwell, then Minister of Fuel and Power, appointed the Mineral Development Committee "To enquire into the resources of minerals in the United Kingdom, excepting coal, oil, bedded ironstone, and substances of widespread occurrence; to consider possibilities and means of their co-ordinated, orderly and economic development in the national interest, and to make recommendations in regard thereto." The report of this committee was published in July, 1949, and with regard to Northumberland and Durham it is stated: "There still remain large areas in the district where the Great Limestone, which is the favourable horizon for ore deposition, is accessible but is as yet unexplored. Dr. Dunham . . . regards an area of about 1½ sq. miles near Killhope, between Nenthead and Allendale, as the most promising. Two further areas lie between Weardale and Nenthead and between Rookhope and East Allendale, neither of which, however, is as promising as that near Killhope." The comment on North-West Yorkshire is less encouraging: "There are no known reserves in this area, and generally speaking, with one or two local exceptions, geological evidence suggests long term prospects are not favourable." Thus, exploration seems to be the next step — not local exploration in independent areas, but serious exploration on a wide scale, co-ordinated by a technical administration with ample funds, public or private, at their disposal, and carried out by a suitably-paid staff of mining engineers and practical geologists. There must be equipment and labour for drilling, trenching, and possibly geophysical surveying. While it is extremely doubtful if there is any more easily-won ore, it is hard to believe that there simply is "no more ore", and that is what we want to find out. The risks are not denied, but at a time when millions are being dissipated in other directions the comparatively small sum needed to satisfy the diehards and the sceptics one way or the other would at least be spent in a worthy cause. REFERENCES
Drawings and Photographs accompanying the article
Article reproduced from a copy of the magazine held at National Mining Museum Scotland, Newtongrange, Midlothian.
|
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 17 Jan 2023
|
Search |
|
|||