|
William Lamb
A fatality at South Hetton Colliery, Durham, again raises the questions of prevention of limber riding and provision of safe clearance between the tubs and the sides. A pony driver, aged 14 years, was riding on the. pony limbers when coming outbye with a set of two full tubs along an almost level bord and pillar roadway about 5ft. 6in, high. It is presumed that the pony stumbled on a slightly wet and uneven floor, causing deceased to fall forward. His head was crushed between the tub and a side prop, which only allowed from 3 to 5 inches clearance. I am convinced that the majority of accidents of this type could be avoided if limber riding were prohibited, but the majority of managers seem to be of the opinion that if such riding were prohibited not only would the rule be more honoured in the breach than in the observance, but that it would result in loss of output and would not produce the results expected from the safety point of view. I do not agree with them on these points. The provision of safe clearance, however, about which I have made suggestions repeatedly in previous reports, is a question apart, and if it received the consideration due to it, would result in an appreciable reduction in the number of haulage accidents due to persons being crushed between tubs and obstructions. As I said last year, the nature of the obstruction varies but is mainly due to either the small or the irregular cross-section of the roadways. In this instance the roadway was about 6 feet high and 9 feet wide. In such a roadway there is no reason whatever why any prop should only allow from 3 to 5 inches clearance from the tub. The clearance between side props and tubs is affected by three things, (1) the straightness of the roadway itself, (2) the straightness of the rail track, and (3) the type and regular alignment of roof supports; and each of these affects the other. As is not unusual in bord and pillar workings, the roadway in question was not driven quite straight; the sides were irregular. The roof was supported by props and planks 7 feet long, set at close intervals. Further, the barrow-way was originally laid by the hewers with short, four feet, light section rails, with which it is very difficult indeed to lay and maintain a straight track. Both of these factors, i.e., rail track and irregular sides, prevented the original setting of the side props in regular alignment, although it would appear that they were originally set to allow a safe clearance between them and the tubs running on the more or less zig-zag track. As the workings advanced the short rails were replaced by long heavy section rails which found the straight line more readily, with the result that occasional props came much nearer to the tubs than formerly. It was at one such prop, which only allowed a clearance from the tub of from 3 to 5 inches, that the fatality occurred. I have dealt at length with the questions arising out of this fatality to show how failure to deal with small details leads to disaster in the long run, and in the hope that managers and officials will give this matter more consideration in the future in order to prevent accidents of this kind which, undoubtedly, can be avoided with little or no trouble or expense.
If you are researching William Lamb (e.g. for family tree purposes) and you would like to hear from others with the same interest then please complete the details in the following form. We will show the information you provide on this page so that you can be contacted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||