|
Walter Jepson
At 4.45 a.m. on July 6th an explosion, causing the loss of three lives, occurred at Barnsley Main Colliery in a machine wall in the Haigh Moor or Ardsley Seam, which is 2 feet 10 inches thick. Mr. Wilson, accompanied by the late Mr. Tickle, visited the mine shortly after noon the same day, and on his arrival found that beyond the removal of the bodies nothing had been disturbed. According to his notes and evidence given at the Inquest, the facts of the case are as follows :— A compressed air coal-cutting machine was at work on a face 100 yards long, some three-quarters of a mile from the shafts. There was apparently a deficiency of air pressure, and the machine, which was started at 11 p.m. on the 5th, had only cut some 24 yards by 4 a.m. the next morning. At about 3 a.m. the deputy, Walter Jepson, visited the place and sent one of the three machine men to the surface to ascertain why the air pressure was so low. Before going, this man, Thomas Moore, informed the deputy that he had drilled four short holes in the face of the coal, which was undercut about four feet. The deputy then withdrew two sprags opposite No. 4 gate (see plan) quite near to the machine, and after asking Moore where the stemming was, said he would fire a shot. Moore then went to the surface, and on returning, after perhaps an hour and a half, was told in the pit bottom that some men who had been working on the main level outbye of the machine face had run out without their clothes, and had reported that "the machine had gone off." The officials got to the district at about 5.30 a.m. and found evidence of an explosion, inasmuch as a stopping was blown out at A (see sketch attached), a door-way was lifted off its hinges at B, and canvas doors in the gate roads Nos. 12 and 3 were torn or blown down. On getting to the bottom of No. 3 gate they heard the machine working, so they partly shut off the air at the stop valve on the main road in order to stop the machine, yet allow some air to escape in case any one was alive near the machine. On reaching the bottom of No. 4 gate they found a canvas sheet intact, but at the face or inbye side of it, a heap of props and an empty tub were burning fiercely. After extinguishing the fire the ventilation was carried forward, and three bodies were found at the points marked C D E on plan. Mr. Wilson and Mr. Tickle made a careful examination of the whole district on the day of the accident, and returned the following day to continue their investigation. Mr. Pickering also inspected the mine on the 8th instant, and on the 15th instant Mr. Wilson revisited the place accompanied by the representative of the Yorkshire Miners' Association. During the course of these investigations, Mr. Wilson came to the conclusion, after careful examination of the coked dust and uncoked dust on the face props, that the origin of the explosion was at a certain point on the face marked F on the plan which he termed a "dividing line." The whole of the undermined coal was resting upon the pavement and opposite No. 4 gate ; the coal was broken as though a shot had been fired, though no signs of shot holes were to be seen. By the 8th instant, however, a portion of the coal had fallen off the face, and revealed a shot hole immediately upon the "dividing line" and 17 feet away from another hole now visible immediately opposite No. 4 gate. The shot firer's cable, 20 yards in length, was got lying stretched out in the slant from No. 4 gate inbye, and his lamp was found on the floor in the slant just 20 yards from the place where shots had been fired. His pocket book and a small electric battery were discovered at the outbye end of the cable. After the coal had been removed from over the coal-cutting machine, it was found that although the machine had previously been cutting inferior coal near the pavement, it had for the last 20 to 30 feet been cutting in hard stone. By the 15th instant the coal at the face had been thrown back to allow closer examination. This removal disclosed behind the original face, and for some yards in length, a slippery break in the roof from which the gas would doubtless issue. On the day of the explosion and following day, Mr. Wilson detected 1½ per cent. of firedamp along the coal face. The explosive used was monobel powder, fired by No. 6 detonators, and the evidence of the store-keeper, and of the quantity of explosive used elsewhere and still remaining in the canister, proved that two shots must have been fired upon the machine face on the night of the explosion. It will be noticed that Hunt's body was found, as shown on plan, only a few yards in front of the machine, and its position can only be accounted for on the supposition that he thought he was in a safe position while the machine was between him and the shot. The fact of the coal cutting machine being found running can be explained in the light of Moore's evidence, that it had worked intermittently for lack of pressure, and the chargeman, Hunt, had not troubled to shut the valve each time it stopped. The valve was found open after the accident. Mr. Wilson summarised his conclusions as follows :— (1.) The explosion occurred in the district in which the shot firer stated he would fire a shot. (2.) The evidence showed that explosive enough for two shots had been consumed. (3.) The presence of coked dust upon the timber pointed conclusively to the position of the 2nd shot hole (F) as the origin of the explosion. (4.) The position of the cable and shot firer's lamp and battery showed that he had just fired a shot. (5.) The machine had been cutting coal and had been making dust. (6.) A fracture in the roof had given off firedamp. (7.) The second shot had little to do, and, producing flame, ignited the gas, as well as the dust left in suspension after the first shot. (8.) The deceased deputy committed the following breaches of Explosives Order of 21st May, 1912, viz. :— Part I. 2. (d). The direction of the shot holes was not "marked on the roof or other convenient place." Part I. (e). He did not see that all persons took proper shelter before firing. Do. (f & h). He was using, unknown to the management, a small dry battery igniter. Do. 5. (f) iii. It is unlikely that he examined the place and all contiguous accessible places before firing the shot. The management endeavoured to convince the Coroner's Jury that the machine wheel of the coal cutter had encountered some pyrites, and, through emitting sparks, ignited some coal dust. The Jury, however, returned the following verdict :— "The three persons died from shock due to burns, and by poisoning due to carbon monoxide. The Jury is of the opinion that the second shot was the cause of the explosion as stated in Mr. Wilson's evidence." It is sometimes held that coal dust at the working face is not fine enough to intensify a gas explosion, but in this case there can be no doubt that it played a very considerable part. As shown on plan, sufficient force developed to displace brick stoppings at a distance of 160 yards from the shot. This explosion shows the necessity for making careful inspections for firedamp after every shot, and for taking efficient steps to render the dust harmless as stipulated in Part II. 5. (f) iii. of the Explosives in Coal Mines Order of the 21st May, 1912, and this cannot be too strongly impressed upon those whose duty it is to carry out the terms of that Order. The deputy is reported to have had instructions from the manager to remove dust before shot firing, and to have been supplied with a brush for the purpose. There is no evidence to show whether the brush was used or not, but in any case it is clear that whatever steps were taken they proved inefficient to render the dust within the area of shot firing harmless.
If you are researching Walter Jepson (e.g. for family tree purposes) and you would like to hear from others with the same interest then please complete the details in the following form. We will show the information you provide on this page so that you can be contacted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 30 Jun 2023
|
Search |
|
|||