|
Arthur Cooper
Shaft Accidents. At Florence, Colliery, North Staffordshire, on the 16th May. — Two young men were killed owing to the cage in which they were ascending the No. 1 shaft getting out of the wood guides and coming into collision with the descending cage. The force of the impact tore the ascending cage from the tacklers and it fell withe the two men to the bottom of the shaft. The shaft is 860 yards deep by 12 feet 6 inches in diameter, and was used for winding coal from an insett at 600 yards. It was fitted with two 3-deck cages each carrying six tubs, and running in pitch pine guides 5 inches square secured to buntons 10 inches by 8 inches fixed about 11 feet apart. An examination of the shaft appeared to show that the cage had got out of the guides about 110 yards below meetings, at which point one of the guide-rods had broken opposite a bunton. The cause of the breakage of the guide-rod could only be conjectured. There was a slight "shake" in the rod at the place, and it would be further weakened there by the bolt hole. Such a breakage, however, could not have been anticipated without some extraordinary cause. The shaft is not quite plumb and this will cause unusual strains to be put on the guide-rods at certain places. The engineman, who had had 24 years' experience at winding engines, said the engine was running at reduced speed, and that he observed nothing wrong until the cages came into collision at meetings, when he stopped it as soon as possible. As the marks in the shaft showed that the cage had been out of the guides for more than 100 yards below meetings, and that it had struck two bearers with great violence a few yards above where the guide-rod broke, it would be probable that if the engine had been running at a reasonable speed for winding men the engineman would have observed that something was wrong, and would have been able to arrest the engine before the cages came into collision. On the other hand if the engine was running quickly, at a speed approaching that of coal drawing, it is probable that he would not have been able to stop it before the collision. Quick running would also cause greater oscillation of an unloaded cage and render breakage of a guide-rod more probable. As no one except the engineman could give any evidence as to the speed, the conjecture that it was excessive is only supported by the marks observed in the shaft. The conditions in this shaft are such that great care should be taken in lowering and raising men. The examinations and repairs had been properly carried out, and strict orders have been given to the enginemen to run at reduced speed when men are being drawn.
If you are researching Arthur Cooper (e.g. for family tree purposes) and you would like to hear from others with the same interest then please complete the details in the following form. We will show the information you provide on this page so that you can be contacted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||