|
H. Longbottom
Three shaft accidents attended with fatal results followed each other in rapid succession at the Rockingham Colliery, near Barnsley, the property of Messrs. Newton, Chambers, and Co. This is a new colliery and one of the shafts had only shortly before reached the Silkstone seam at a depth of about 350 yards. This is a new colliery and one of the shafts had only shortly before reached the Silkstone seam at a depth of about 350 yards. Arising in some measure from this last-mentioned accident, another followed on the 2nd October, by which the enginewright at this colliery, H. Longbottom, was so severely injured that he died a week afterwards. A scaffold fixed at the bottom of the shaft was broken by the man and corve falling on to it on the 30th September, and it was for the purpose of superintending the repair of this that Longbottom with his son and two other men descended the shaft on the above-named day. They went down No 2 shaft and proceeded to the bottom of No. 1, where the scaffold was. Before going down Longbottom told the engineman at No. 1 shaft engine that they were going to the bottom of No. 1 shaft and when a signal was given he was to pull the cage up. This was done and the cage remained stationary some seven feet above the men for nearly an hour, at the end of which time it came down on to the scaffold crushing both the Longbottoms, the father so severely as to cause his death. The other men said that no signal whatever was given. The engineman's explanation of the matter was that when he had raised the cage to the height named he observed that it kept moving a little so he put the steam against it to keep it still. Remaining so for nearly an hour he shut off the steam and tightened the break handle by one hole and then he commmenced cleaning his engine. The cage now began to lower, and the accident occurred. It seemed to me very improbable that the engine would stand for nearly an hour and then begin quietly to creep, unless something was done to it. One of the special rules states that an engineman must remain at the handle and the break when any person is in the shaft. This clearly Webster, the engineman, did not do, though he stated that being little more than three feet from the handle at the time, he considered the rule was not violated. Of course this is his statement; but it is possible that had he been at the handle he might have stopped the engine so soon as it began to move. The deceased was a careful man and an experienced enginewright, about 55 years of age, and he would seem to have depended a good deal on the verbal instructions he himself gave the engineman before going to the scaffold.
If you are researching H. Longbottom (e.g. for family tree purposes) and you would like to hear from others with the same interest then please complete the details in the following form. We will show the information you provide on this page so that you can be contacted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||