|
Samuel Edwards
Ropes and Chains Breaking I have one accident under this heading to which I wish specially to refer. As will be seen by a reference to accident No. 10 in my list, this took place at the Snailbeach Mine, in Shropshire, and caused the death of two men. They had been employed as timbermen for many years, and at the time of the accident were engaged upon some necessary repairs of the timber-work in one of the most important shafts of the mine. In order to enable them to perform this work they had to be lowered from the surface by means of a capstan worked by men, a nine-inch rope, and a cage or gig in which they stood while descending and ascending and which served as their platform while they were performing their work in the shaft. While they were thus engaged the rope gave way and they were precipitated to the bottom of the shaft, a vertical distance of 150 yards. Although the age of the rope was so great that I failed to ascertain at the inquest how long it had been in use, it appeared to be strong enough to bear a much heavier weight than that applied to it on this occasion; but an examination of the part that broke showed very clearly that the coupling by which it was attached to its load had not been attended to for a long time, and as it transpired in evidence that this important duty had been assigned to one of the deceased men — a man chosen for his experience and skill — the agents of the mine were to some extent freed from blame. It is well known that ropes, whether of iron or of hemp, almost always give way either inside the socket into which the end is inserted, or exactly at its top-point A. in the accompanying sketch. This fact shows the importance of frequent and thorough examinations at this part of all ropes on which human life and safety depend. A fresh hold should be taken as soon as the least defective appearance is detected. The process of joining ropes to each other or to the loads they are intended to carry is one which demands much care and skill. In a steel rope which gave way recently at a mine in my district, the appearance of the broken strands indicated too clearly that many of the wires had been severed in the operation of attaching the socket.
If you are researching Samuel Edwards (e.g. for family tree purposes) and you would like to hear from others with the same interest then please complete the details in the following form. We will show the information you provide on this page so that you can be contacted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||