The installation of an electrically driven man-haulage system at Vane Tempest Colliery, Seaham Harbour, provides an excellent example of the speeding up in movement of men and the saving in man-hours which can be brought about by such mechanisation. The complete electrical equipment for this drive was manufactured by General Electric Co., Ltd., the work was engineered by the staff of the National Coal Board and the mechanical equipment was supplied by Messrs. John Tinsley and Co. Ltd.
At present a single-rope haulage system is being operated over a distance of a mile in-bye, but it is intended ultimately to adopt main and tail working over a distance of 2½ miles. With the existing system, a train consisting of eight cars carrying 130 persons is being used. An ambulance car can also be accommodated on the same train if required. The train runs at 10 miles per hour, gradients up to 1 in 7.1 being easily surmounted.
All the electrical equipment is housed in a ventilated brick built haulage engine room below ground, and operates on 2,760 volts, 3-phase, 50-cycles. The 350 horse-power motor is of the 3-phase, heavy duty induction type, and runs at 365 revolutions per minute, the slip-ring gear being fully flameproof.
The incoming 2,750-volt supply is taken through a flameproof oil circuit breaker of the draw-out typo, incorporating overload releases. This circuit breaker controls the supply to the haulage motor and to a 2½-K.V.A. transformer, which reduces the voltage to 110 and feeds a flameproof ironclad distribution board.
An oil immersed flameproof stator reverser and liquid controller controls the haulage motor. The forward and reverse contactors of the reverser are designed to give two breaks per phase and are so interlocked that it is impossible for one set of contacts to be closed until the other set is open. Safety interlocks are also provided.
Float switches fitted to the liquid controller give audible warning of a fall in the level of the electrolyte, and eventually trip the main oil circuit breaker before the electrolyte can reach a dangerously low level.
The equipment is operated from a gate lever which is mechanically coupled to the liquid controller, and also connected to a flameproof master controller actuating the stator reverser. This lever is so arranged that the first few degrees of its movement operate the master controller, thus energising the closing coils of the stator contactor.
Both the circulating cooling water pump of the liquid controller and the motor operated thruster brake are controlled by flameproof direct-to-line contactor starters, fed from the distribution board.
Lighting for the engine house itself is supplied from a separate 500-VA. flameproof transformer, which is a self-contained unit with its own busbar chamber.
Rail limit switches are provided to prevent overwinding at the loading station, while the motor operated thruster brake prevents overspeeding. A signalling system is arranged from the train attendants' car to the haulage driver and an emergency or "stop" signal can be given when the train is travelling at full speed.
Vol. LIX, No. 3, Saturday, July 31, 1948
Source: The Science & Art of Mining