Owing to the frequent existence of fairly strong strata with well-defined bedding planes in the main roadways of some of the mines in this Division, many of the managers prefer the ordinary square form of support — which is usually handier to erect — for the roof and sides, and consider the extensive use of steel arches unwarranted, because of the difficulty involved in either making the little extra excavation that may be necessary for the erection of the arches, or in completely packing the arches once they are erected in order to distribute the load evenly over them. They do recognise to some extent, however, the superiority of steel over timber as a support and consequently many miles of roadways, especially those intended to last a long time, are supported by straight girders, generally with wood props at either end.
In this connection I should like to call attention to an interesting departure at Tursdale Colliery, Durham, where a portion of one of the main roadways is being successfully supported by a complete framework of straight "H" section girders. They are erected as shown in Plate IV. The portion of roadway is in somewhat disturbed ground and is unusually high owing to the proximity of the top and bottom sections of the Busty Seam which are separated by a dirt band. The supports are set about 2ft. 6in. apart. The roof girders are first supported in advance by means of the "Lazy-man" or safety girder. The side girders are then attached, sole piece fitted, wedged tight from the bottom, and finally grouted in at the foot with concrete. Two men per shift do all the work, including the drilling of any additional bolt holes that may be necessary.
Source: 1928 Mines Inspectors Report