At Thornley Colliery, Durham, an ascending fully-loaded cage was stopped about fifty feet from bank owing to the heapstead being stocked with full tubs due to a breakdown on the screens. During the stop the winding engineman proceeded to do some oiling and cleaning. Shortly afterwards the banksman gave a signal "one" and the engineman, in error, started away as if for a complete wind, with the result that an overwind took place. The overwinding gear, which was set to come into operation 2 feet 6 inches above the flat sheets, apparently operated, but owing to the high speed the cage was not pulled up until the" bell "was reached 10' 6" away, and the detaching hook had come into operation. The hook operated properly but the rebound of the cage on the chains broke the shackle pin and the cage and chains were precipitated to the shaft bottom. The winding engineman frankly admitted he had been at fault but the banksman was not entirely free from blame as he should have given the raise steadily signal of "4."
The fact that this cage went to the bottom of the shaft, again illustrates the necessity for all colliery managers and engineers to give serious consideration to the question of installing means to prevent the cage from falling back even the full length of the chains in the event of an overwind and operation of the detaching hook, by the installation of headgear keps.
Source: 1927 Mines Inspectors Report