At one of the pits of the Seaton Delaval Colliery, a 10-inch diameter shaft fractured close to the crank while a cage containing two empty tubs was being raised. The engineman heard a sharp crack and applied his brake and held the drum, so that no further damage was done. The engine was very similar in size and construction to the one mentioned above.
Only a week previous to this a 9 ½-inches diameter steel drum shaft belonging to a pair of horizontal engines at another pit worked by the same owners fractured close up to the drum while coal was being wound. In this case also the engineman heard the crack and was able to hold the drum by means of the brake. The fracture was a clean one, but there were signs that the outside portion had been cracked before, but owing to its position it would have been very difficult to detect the flaw during an ordinary examination.
Source: 1914 Mines Inspectors Report (Cd 8023)
Fortunately the mines in the Northern Division are characteristically free from gob fires; several underground fires have occurred in the past, however, and while their actual cause was doubtful they may have originated spontaneously.
Interest, therefore, is attached to the occurrence of a pure gob fire which was discovered in the Main Coal Seam in the Richard Pit of the Seaton Delaval Colliery on 19th April, 1914. The fire was not attended with much danger as no gas was present, and it was not difficult to deal with. The method of working the seam was longwall, the gate roads being 22 yards apart. It was midway between two of these gates that the fire started at a point about 40 yards from the face. The gate packs were 3 to 4 yards thick and were built with post and inferior coal. There were many conditions favourable to the formation of fires in the goaf of this seam, viz.
1. About 21 inches of inferior coal, containing much finely disseminated pyrites, was thrown in the goaf.
2. About half of the timber set was left in the goaf.
3. The seam was a little moist in places.
4. There was a post roof which would tend to keep in any heat generated and the fissures formed in the post would enable air to penetrate into the goaf.
In order to deal with the fire, a "scouring" road was driven through the goaf at right angles to the gate roads. Fire was found on both sides of this road and was gradually dug out Attention was chiefly paid, at first, to the fire on the inbye side, in order to completely isolate the fire. A water supply was quickly obtained from the rising main. It was found, however, that the steam produced had a very deleterious effect on the roof and several small falls occurred on the return side. Flue dust thrown on to the fire in quantity was found to be far more effective. A considerable number of burning props were found, and, as was to be expected, the pyrites in the inferior coal near the fire showed various stages of oxidation. As the fire was filled out the opening was filled up with post stone embedded in flue dust so that the stowing was incombustible and, as far as practicable, air-tight. Thermometers were placed in the goaf at various places in the district to see if heating was taking place elsewhere, and these were read and recorded periodically by officials.
Source: 1914 Mines Inspectors Report (Cd 8023)