On September 5th, a quarryman was injured about the hands and face, at Raisby Hill Quarry, by an explosion of a charge of powder while a hole was being charged. Two men, after drilling a shot hole, which was 1¼ inches in diameter and 3 feet deep, put a charge of about 6 inches of powder to crack the hole before putting in the main charge, as the stone was very hard ; after this small charge had exploded they cleaned out the shot hole, first with an iron scraper and then with a wisp of grass, and then put in a charge of 18 inches of powder, which they measured by inserting the iron scraper with a mark on it to show when the hole was full enough ; they had just done this and were about to withdraw the scraper and put in a wooden stemmer when the explosion took place and the iron scraper was blown out of the hole. The men said they had no idea that the iron scraper, as a measuring rod, had played any part in the explosion, but thought a small piece of fuse, with which the first charge had been exploded, had got into a crack or crevice caused by the explosion of that charge, and still been "alive" when some powder reached it, and caused the explosion. They may possibly have been right in this supposition, but it is just as likely that the iron scraper had been the cause of the explosion. The manager gave orders, after this accident, that wooden stemmers were to be used as measuring rods in future, and that on no account was any iron rod to be inserted after an explosive had been put into a shot hole.
Source: 1903 Mines Inspectors Report (Cd 2119), Durham District (No. 4) by R. D. Bain, H.M. Inspector of Mines