|
Fishburn CollieryMiscellaneous Notes and IncidentsFishburn Colliery, Durham (Below ground — Accidental shotfiring from a signalling system) : A deputy and three stonemen working in a drift received injuries when a charged shot ignited prematurely. It appears that one shot had already been fired and preparations had been made to fire the remainder. The oversman who visited the face at this time, said later that he found the deputy holding the end of a length of shotfiring cable and presumed that it was the usual cable which was normally supplied from the exploder kept in a recess at the top of the drift. He had just left the face, and was making his way up the drift, when he heard the sound of a shot being fired and hurried back to the face where he found the deputy and two of the men suffering from slight cuts. The other man had sustained rather severe injuries. The oversman then pulled the shotfiring cable from under the debris and, upon tracing it up the drift, found it that was connected to the signalling system instead of, as intended, to the shotfiring exploder. The signalling circuit was supplied from a certified signalling transformer giving an output of 24 V.A. at 15 volts A.C., and one bell of the approved type was used in the circuit. No electricity for power purposes was used in the drift. When investigations were made, it was found that a stoneman on another shift had, for the convenience of giving a signal, connected a length of discarded shotfiring cable to the signalling system, and the deputy, apparently not aware of this, had attempted to connect the end of the live cable to the detonator wires, with the obvious result that the detonator, a No. 7 H.T. type, was ignited and the charge of 4 ozs. of Polar Saxonite was detonated. Although the signalling system was of the intrinsically safe type, and incapable of igniting firedamp, such detonators could be fired under the circumstances stated. Shotfiring cable should not be used for signalling purposes. Discarded shotfiring cables should be taken out of the pit, and signal wires should be extended as required. Source: Report of H.M. Principal Electrical Inspector of Mines for 1949, from a copy held in the Scottish Mining Museum, Newtongrange, Midlothian
|
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||