No. 388 on the list occurred at Denby Grange Colliery, on December 15th last, and caused two men to be slightly burned. The accident occurred at 6.30 p.m. in the face of a bord in the New Hards seam.
The men were working a Jeffrey heading machine driven by electricity. The motor was supposed to be flame-tight, and worked at 500 volts. They had made and filled away the coal from two cuts, and were stopping extra time to cut under again. One of them bored two shot-holes in the face near the roof, ready to blow the coal down when it was undercut, and had just switched on the current ready to enter the face when the small cable connected to the field coils broke where it entered a fibre plug in the machine frame, and short circuited on the frame, and caused a flash which ignited a small quantity of gas at the face, and burned both men very slightly about the neck. The man who drilled the shot-holes said he had examined the place carefully for gas before doing so, but could find none. There is little doubt that it was given off by the holes he drilled. Fortunately there was a very small quantity of gas, or the consequences might have been much more serious. The accident shows how necessary it is that every part of electric motors should be carefully examined, and also the cables, especially where they pass through the flame-tight cover, as this one did.
Source: 1904 Mines Inspectors Report (Cd 2506), York and Lincoln District (No. 5) by W. Walker, H.M. Inspector of Mines