An explosion in a Blacksmith's fire caused injuries to a blacksmith at Dawdon Colliery, Durham. Investigations show that similar explosions have frequently occurred at other pits where percussive coal cutters are used. The tapered end of the steel rod of a percussive coal cutting machine fractured in the correspondingly tapered hole or socket of the five prong pick attached to the rod. The blacksmith, in order to release the broken end of the rod, heated it in the fire under forced draught. After a short time, he was leaning towards the fire in the act of turning the pick when suddenly there was an explosion and the pick, together with a considerable amount of burning coal, was blown out, causing rather severe burns to his chest. The piece of broken rod was blown out of the socket.
There are two possible explanations of the explosion:
(a) When the pick was forged on to the rod, an air cavity was left between the end of the rod and the bottom of the socket. When heated, the expansion of the air pocket was sufficient to force the rod end and pick apart with violence.
(b) A certain quantity of coal dust was in the cavity, and under heat the coal was distilled and gases of an explosive character were generated which were ultimately exploded by the heat.
In order to prevent such accidents, a hole should be drilled down the centre of the rod left in the socket, thus providing an outlet to the air pocket at the base.
Source: 1930 Mines Inspectors Report