At one of the pits of the Bedlington Colliery, Northumberland, while coal was being wound, the engineman stated that about 2.15 p.m. he heard a strange noise in the engine house. He thought it was something wrong with the engine, so he stopped it and called in the assistant enginewright. The enginewright and his assistant went and examined the engine and found nothing wrong. Winding was resumed and all went well until an hour afterwards when the engineman again heard the noise, He was not satisfied and again called in his superior. They re-examined the engine and failed to find anything wrong. The engineman then moved the engine slowly, the enginewright being near the drum shaft, and when the full cage was about 28 yards from the top the drum shaft suddenly snapped and the drum dropped several inches. The fracture took place exactly where the greatest strain would be, viz., just inside the bearing. This drum shaft had been in use 59 years. At the point of the fracture it was 13½ inches in diameter, being a little larger between the bearings. The officials considered that they always made a very careful examination, but they never took the covers off the bearings. Had they done so in this case they probably would have discovered a fracture, which evidence seems to point to as having taken place when the first warning was given. The engine in this case also was one of the old vertical single-cylinder type.
Source: 1914 Mines Inspectors Report (Cd 8023)