|
Oldham and Son Limited FORM F OR CONVERSION LAMP — This lamp was introduced to enable customers who had been using Oldham standard 2-volt lamps to convert their equipment to high-candlepower 4-volt lamps by making certain changes, thus avoiding the cost of new lamps. The 2-volt lamp is converted by the insertion of a 4-volt accumulator and deeper lamp bottom, new bulbholder, 4-volt 3-watt bulb, and prismatic glass, and in its new form weighs 7½ lb. The accumulator is of the lead-acid type, and incorporates the Oldham snap-lid feature (illustrated on the extreme right) which enables the plates to be removed from the case in less than 5 seconds. The lamp is illustrated immediately above, the left-hand view showing the complete lamp and the right-hand view the components.
SUPER 4-VOLT LAMP. — The S Type or Super Hewers' Lamp is an entirely new design, and there being no limits to dimensions as was the case with the Form F lamp, full scope was available to design a lamp having excellent candlepower characteristics together with robust construction. The S Type lamp has a weight of 9½ lb., as against 7½ lb. for the Form F, but the candlepower characteristics are correspondingly higher and the performance on a basis of lumens per lb. weight is practically the same. The S Type lamp follows the same general lines as the Form F, but owing to the freedom in the matter of dimensions it has been possible to introduce a system of armouring the positive plates by sheets of perforated ebonite veneer; double separation of the cells has also been adopted. This lamp has been in actual service for some two years, and is said to have amply borne out the claims made for it.
TYPE D CAP LAMP — Although the existing Oldham cap lamps comply with the Regulations, the Type D cap lamp made by this firm has been introduced to meet the demand for an efficient high-candlepower lamp. The use of a 4-volt bulb enables a higher efficiency to be gained, and the new lamp has a candlepower between 14 and 20 according to the type of bulb and reflector used, together with a light distribution satisfying the Regulations. A jelly electrolyte is adopted for the battery, and the headpiece is moulded solid with metal inserts and reinforcement in high-pressure synthetic resin. The switch can be mounted either on the headpiece or on the battery.
Drawings and Photographs accompanying the article
Article reproduced from a copy of the magazine held at National Mining Museum Scotland, Newtongrange, Midlothian.
|
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 17 Jan 2023
|
Search |
|
|||